MANAGE THE LASER POWER
CMOS sensors have low saturation levels as well as low damage thresholds. It is thus very important that you control your laser power to get the best measurement possible and avoid damaging the BEAMAGE camera.
Sample your laser beam
The BA series optical attenuators use Fresnel reflection on two orthogonal wedges to pick off a small fraction of the input beam. The incoming beam polarization state and irradiance are preserved.
Many possible uses
- Monitor power and beam profile simultaneously
- Polarization insensitive beam-splitter with no back-reflections
- Optical pick-off for use with our energy or power detectors
- Attenuator for our high sensitivity detectors like M6 series and PH series
Beam profiling camera. High-resolution CMOS sensor, ISO-compliant measurements.
Beam profiling camera with phosphor coating for IR wavelengths (1495-1595 nm). High-resolution CMOS sensor, ISO-compliant measurements.
Beam profiling camera. 4.2 MPixel high-resolution CMOS sensor, ISO-compliant measurements.
Beam profiling camera with phosphor coating for IR wavelengths (1495-1595 nm). 4.2 MPixel high-resolution CMOS sensor, ISO-compliant measurements.
ND filter for BEAMAGE camera.
Spectral range200 - 2100 nm
Integrated power detectorN/A
Optical wedges materialUV Fused Silica (uncoated)
Residual beam deviation5.6°
Polarization correctionYes (pair of orthogonal wedges)
Maximum average power density10 MW/cm²
Maximum energy density10 J/cm²
Maximum power60 W
Aperture diameter16 mm
Dimensions45H x 47W x 81D mm
Adaptor includedSM1 external threaded tube
There is no document to download for this product. Contact us for technical details.
The BA Series Optical Attenuators use Fresnel refl ection on two optical wedges to pick off a small percentage of the input beam. Since the wedges are oriented orthogonally, the S and P polarization states are switched when the refl ected beam hits the second wedge, and the difference in refl ectance between the two states cancels out. The incoming beam polarization state and irradiance are thus preserved. The wavefront distortion is negligible and the laser output power stability is not affected.
MONITOR POWER AND PROFILE SIMULTANEOUSLY
The BA16K models include a calibrated thermal power detector that also acts as a beam dump. Simply plug the detector into a Gentec-EO Power Meter to measure and display relative power in real time.
To obtain an absolute measurement of power, you will have to determine a correction factor for the BA16K. This can be accomplished in few simple steps. Note, however, that such a correction factor is dependent on the laser polarization and will only be valid if the polarization is stable over time.
In the near future, a power measurement feature will be added to the PC-Beamage software which will then be able to display the laser power density.
The “Sampled beam” port can be connected to the Beamage via the included adaptor tube. The adaptor tube is also compatible with our ND fi lters for additional attenuation (recommended for small beams at high power). An ND4 fi lter is always included with the purchase of a Beamage profi ling camera.
The BA Series Optical Attenuators can also be used, stand-alone, as follows:
- OPTICAL PICK-OFF FOR USE WITH OUR ENERGY OR POWER DETECTORS
- ATTENUATOR FOR OUR HIGH SENSITIVITY DETECTORS LIKE M6, PH, ETC.
- POLARIZATION INSENSITIVE BEAM-SPLITTER WITH NO BACK REFLECTIONS
Your item has been added to your cart!
You might need these specific products to be able to use the placeholder only.
No compatible product